Armasight IR810W Detachable Wide Range Angle Adjustable Long Range Infrared Illuminator

Armasight IR810W Detachable Wide Range Angle Adjustable Long Range Infrared Illuminator will allow you to use your night vision monocular in areas like deep forests, darkened rooms, caves, and anywhere else where there's no available light source to draw from. The Armasight night vision accessory . The Arma-Sight IR-810 Night Vision Monocular IR Illuminator can illuminate an area up to 100 meters in front of your monocular, and the night vision accessory gives you greater control over battery life with an adjustable brightness rate. The illuminator can be installed in either a vertical or horizontal alignment to match the alignment of your night vision monocular. Armasight has built the infrared illuminator for the Gen 1 and Gen 2 night vision monoculars. Illuminate even total darkness with the Arma-Sight IR810 Night Vision Monocular Infrared Illuminator.


RATING
92 /100
  • Design

    Excellent

  • Performance

    Excellent

  • Value for money

    Excellent

  • Feature

    Excellent

Specifications for Arma-Sight IR810 Infra-Red Illuminator for PVS-7 NV Monocular:

Power: 600 mW
Wavelength: 810nM
Illumination Range: up to 500m
Compatibility: Gen 1, Gwn 2

Features of Armasight IR-810 NV Monocular Infrared Illuminator:

  • Image-enhancing infrared illuminator for night vision monoculars by Armasight
  • High power IR-emitting diode
  • Precise adjustment of beam direction
  • Power adjustment
  • Wide range beam angle adjustment
  • Eye safe
  • Lightweight and rugged
  • Ideal aid for extreme low light conditions
  • Mounts on the weaver rail or uses as handheld
  • Limited two-year warranty

1-Armasight IR810W Detachable Wide Range Angle Adjustable Long Range Infrared Illuminator
2-Armasight IR810W Detachable Wide Range Angle Adjustable Long Range Infrared Illuminator
3-Armasight IR810W Detachable Wide Range Angle Adjustable Long Range Infrared Illuminator

Enjoyed this article? Stay informed by joining our newsletter!

Comments
Madison - Add Reply

This IR light works very well as an adjunct to my Armasight Orion 4x night vision scope for feral hog and coyote hunting in the Texas hill country. My Orion came equipped with the IR810 light, but after a technical consultation with Steven B at Armasight, I decided to try the IR810W. I was skeptical - having dropped a lot of cash over the years on supposed upgrades that did not pay off -but this one absolutely did. The boost in output power from 120mW to 600mW gives me far more viewing distance and clarity, even on moonless nights. Quickly attaches to my Orion Weaver rail with the included mount, and the beam width adjustment and the variable output switch are easy to find without fumbling around. (The beam width adjustment is a very handy feature, but a little sticky to turn). The output selector has an OFF switch at each end of the cycle, so no need to flip through them all to turn it OFF (although I almost always use the highest power setting). I did not think that the beam direction adjustment would be that helpful, but found that having the IR beam directly centered in my reticle is not always beneficial (when I have red crosshairs on a black hog at under 100 yards it can be distracting), so I just reach up and give it a tweak. It stays put until I move it again, even after bonking around in the brush on my sling. Also using it with my Yukon Ranger monocular for extra range when scanning. It makes whitetail, fox and coyote eyes look like white reflectors - even... Read More...

You must be logged in to post a comment.

You must be logged in to post a comment.

Related Articles